DESOXY 250ml Rust Remover
DESOXY removes all traces of rust from ferrous metal surfaces by dissolving ferrous and ferric oxides and transforming them into soluble and stable salts.
It forms an anti-corrosion protective layer that lasts for several weeks. DESOXY can be used either by direct brush application or by immersion.
INSTRUCTIONS FOR USE
Wear gloves and goggles.
Apply the product generously on the surface with a brush or by dipping.
Leave to act for 15 minutes (for soaking, it is advisable to leave to act for at least 30 minutes).
At the end of the action time, your part should be covered with a layer of phosphate (white salts deposited on the surface) and all your corrosion spots should have disappeared or turned black.
Brush or card the blackened spots/areas with steel wool type 0000.
Rinse the surface thoroughly with clean water.
Wipe the surface with a clean cloth and allow the part to air dry.
Repeat the operation if corrosion remains (no risk for the surface, DESOXY does not attack healthy surfaces).
Once the surface is completely dry and free of rust, apply a coat of FINISH or ARMELUB.
Beware of rusty springs or small mechanisms, they must be treated separately with a very diluted solution, 5% to 10%, to avoid possible risks of breakage.
Contains: phosphoric acid, less than 5 %: nonionic surfactants (Alkyl Ether Carboxylic Acid). H314 Causes severe skin burns and eye damage. Keep out of reach of children. Wash skin thoroughly after handling. Wear protective gloves/protective clothing/eye protection/face protection. IF SWALLOWED: Rinse mouth. DO NOT induce vomiting. IF IN EYE CONTACT: Rinse cautiously with water for several minutes. Remove contact lenses when present and easy to do. Continue rinsing. Call a POISON CENTRE/doctor immediately. Dispose of contents and container in accordance with local and national regulations. Use only for intended purpose and in accordance with directions for use.